Home › Engine / Hybrid System › 1AR-FE COOLING › RADIATOR › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019676 1AR-FE COOLING _0109794 RADIATOR G

1AR-FE COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16401 1.CHECK RADIATOR CAP SUB-ASSEMBLY

a.
A107446C03
0.479,1.031 0.698,1.229 0.219,0.198 10 false *a 0.708,1.333 1.021,1.49 0.313,0.156 10 false *b 1,1.604 1.313,1.76 0.313,0.156 10 false *c 2.344,1.573 2.656,1.729 0.313,0.156 10 false *d
*a Rubber packing (1)
*b Rubber packing (2)
*c Rubber packing (3)
*d Valve seat


Measure the valve opening pressure.

i.

If there are water stains or foreign matter on the rubber packings (1), (2) or (3), clean the part(s) with water and finger scouring.


ii.

Check that the rubber packings (1), (2) and (3) are not deformed, cracked or swollen.


iii.

Check that the rubber packing (3) and valve seat are not stuck together.


iv.

Apply engine coolant to the rubber packings (2) and (3) before using the radiator cap tester.


v.

When using the radiator cap tester, tilt it upward 30° or more.


vi.
A104601C11
0.375,0.896 0.375,1.521 false 1.719,0.823 1.885,0.365 1.885,0.365 2.094,0.365 false 2.146,0.281 2.323,0.479 0.177,0.198 10 false *a 1.333,0.958 1.531,1.146 0.198,0.188 10 true *b 0.302,1.573 0.479,1.771 0.177,0.198 10 false *1
*1 Radiator Cap Sub-assembly
*a Radiator Cap Tester
*b 30° or more


Pump the radiator cap tester several times, and check the maximum pressure*1.

Pumping Speed:

1 pump per second


*1: Even if the radiator cap sub-assembly cannot maintain the maximum pressure, it is not a defect.

Judgment Criteria:
Item Specified Condition
Standard value
(for brand-new cap)
93 to 123 kPa (0.9 to 1.3 kgf/cm2, 13.5 to 18.0 psi)
Minimum standard value
(for used cap)
79 kPa (0.8 kgf/cm2, 11.5 psi)


If the maximum pressure is less than the specified pressure for the minimum standard value, replace the radiator cap sub-assembly.