Home › Drivetrain › U660E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM › 2013.12–2016.11
RM3160E _52 Drivetrain _019725 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0109807 AUTOMATIC TRANSAXLE SYSTEM D

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  MONITOR DRIVE PATTERN  


TEST MONITOR DRIVE PATTERN FOR ECT


CAUTION:

Perform this drive pattern on a level surface and strictly observe the posted speed limits and traffic laws while driving.


HINT:

Performing this drive pattern is one method to simulate the TCM (ECT) malfunction detection conditions.

Some DTCs may not be detected through ordinary, everyday driving. Also, DTCs may not be detected through this drive pattern.


a.

Preparation for driving

i.

Warm up the engine sufficiently (engine coolant temperature of 60°C (140°F) or higher).


ii.

Drive the vehicle when the atmospheric temperature is -10°C (14°F) or higher.

Some malfunctions are not detected when the atmospheric temperature is less than -10°C (14°F).



b.

Drive pattern

i.

Drive the vehicle through all the gears.

Stop → 1st → 2nd → 3rd → 4th → 5th → 6th → 6th (lock-up ON).


ii.

Confirm engine braking using the S position. While driving with S6 range selected and 6th gear operating with lock-up on, move the shift lever toward "-" to downshift from 6 to 5, 5 to 4, 4 to 3, 3 to 2, 2 to 1.


iii.

Repeat the above drive pattern three times or more.

NOTICE:
·

When using the GTS, the monitor status can be checked in the Data List.

Click hereDrivetrain>U660E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>DATA LIST / ACTIVE TEST

·

In the event that the drive pattern must be interrupted (due to traffic conditions or other factors), the drive pattern can be resumed and, in most cases, the monitor can be completed.



C115866E69
2.542,3.885 1.615,2.49 false 3.385,3.438 3.115,3.042 false 2.188,1.74 2.729,0.292 2.729,0.292 2.792,0.292 false 4.875,2.073 5.177,1.26 5.177,1.26 5.24,1.26 false 0.198,0.438 1.146,0.646 0.948,0.208 10 false Vehicle Speed 2.865,0.208 6.042,1.01 3.177,0.802 10 false Maintain a constant speed or gradual acceleration (with the throttle valve open) for 3 minutes or more.* 5.302,1.188 7.094,1.729 1.792,0.542 10 false Lock-up ON Vehicle Speed 3.417,3.417 4.833,3.771 1.417,0.354 10 false Stop (Idling) 2.531,3.917 4.542,4.604 2.01,0.688 10 false Normal acceleration through all gears from 1st to 6th 0.135,3.302 1.667,3.583 1.531,0.281 10 false Warmed up sufficiently 0.969,2.906 1.135,3.125 0.167,0.219 10 false 0 0.167,1.927 1.083,2.5 0.917,0.573 10 false Approximately 80 km/h (50 mph) 0.167,1.083 1.083,1.667 0.917,0.583 10 false Approximately 100 km/h (62 mph)

HINT:

*: Drive at a speed in highest gear that will cause lock-up to engage. The vehicle can be driven at a speed lower than the speed shown in the above diagram under lock-up.


NOTICE:

It is necessary to drive the vehicle for approximately 30 minutes to detect DTC P0711 (ATF temperature sensor malfunction).