Home › Drivetrain › U660F AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM › 2013.12–2016.11
RM3160E _52 Drivetrain _019726 U660F AUTOMATIC TRANSMISSION / TRANSAXLE _0109808 AUTOMATIC TRANSAXLE SYSTEM C

U660F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  P0560  System Voltage  


DESCRIPTION

The battery supplies electricity to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history and freeze frame data. If the battery voltage falls below a minimum level, these memories are cleared and the TCM determines that there is a malfunction in the power supply circuit. When the engine is next started, the TCM will illuminate the MIL and store this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0560 System Voltage Open in TCM back-up power source circuit.
DTC is detected for 3 sec. or more (1 trip detection logic)
·

Open in back-up power source circuit

·

SFI system

·

TCM


Comes on DTC stored

HINT:

If DTC P0560 is set, the TCM does not store other DTCs.


WIRING DIAGRAM

C301507
6.177,2.396 6.635,2.594 0.458,0.198 10 false ECM 5.885,2.396 6.198,2.594 0.313,0.198 10 false C3 5.833,1.479 6.146,1.677 0.313,0.198 10 false E1 5.646,1.375 5.802,1.573 0.156,0.198 10 false 8 5.823,0.885 6.438,1.083 0.615,0.198 10 false BATT 3.542,1.042 4.771,1.24 1.229,0.198 10 false EFI NO.1 1.885,1.052 3.115,1.25 1.229,0.198 10 false EFI-MAIN 0.75,1.313 1.823,1.51 1.073,0.198 10 false FL MAIN 0.917,1.958 1.99,2.156 1.073,0.198 10 false Battery 5.635,0.792 5.896,1.021 0.26,0.229 10 false 1

PROCEDURE

1.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 234

e.

Read the DTCs using the GTS.

Result:
Result Proceed to
DTCs are not output A
DTC P0560 is output (SFI system) B




A

2.INSPECT TCM (POWER SOURCE, GROUND)

B

GO TO DTC P0560 (SFI SYSTEM)

2.INSPECT TCM (POWER SOURCE, GROUND)
a.

Disconnect the TCM connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
C3-1 (BATT) - C3-8 (E1) Always 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C3-8 (E1) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - BATTERY, BODY GROUND)