The No. 2 air conditioning control assembly communicates with the air conditioning amplifier assembly via LIN communication.
If the LIN communication system is malfunctioning, the air conditioning amplifier assembly does not operate even if the No. 2 air conditioning control assembly is operated.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory |
|---|---|---|---|---|
| B14B3 | Lost Communication with Rear Panel LIN | Lost communication with No. 2 air conditioning control assembly | ·
Harness or connector between No. 2 air conditioning control assembly and IG power source ·
Harness or connector between No. 2 air conditioning control assembly and body ground ·
LIN communication system ·
No. 2 air conditioning control assembly ·
Air conditioning amplifier assembly |
Memorized
(10 sec. or more)*1 |
*1: The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the brackets.
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the U1 No. 2 air conditioning control assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U1-6 (IG) - Body ground | Ignition switch off | Below 1 V |
| U1-6 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U1-7 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F81 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U1-12 (RLIN) - F81-16 (RLIN) | Always | Below 1 Ω |
| U1-12 (RLIN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the No. 2 air conditioning control assembly.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING PANEL>REMOVAL
Since the No. 2 air conditioning control assembly cannot be inspected while it is removed from the vehicle, replace the No. 2 air conditioning control assembly with a new or known good one and check that the condition returns to normal.
No. 2 air conditioning control assembly operation returns to normal.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (When troubleshooting according to Problem Symptoms Table) | B |
| NG (When troubleshooting according to the DTC) | C |
A
B
C