The blower motor with fan sub-assembly is operated by signals from the air conditioning amplifier assembly. Blower motor speed signals are transmitted in accordance with changes in the duty ratio.
Inspect the fuses for circuits related to this system before performing the following procedure.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Air Conditioner / Active Test.
Check the operation by referring to the table below.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Blower Motor | Blower motor with fan sub-assembly | Min.: 0
Max.: 31 |
- |
| Tester Display |
|---|
| Blower Motor |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (Blower motor with fan sub-assembly does not operate) | B |
| NG (Blower motor with fan sub-assembly operates but does not change speed) | C |
A
B
C
Disconnect the F82 blower motor with fan sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F82-1 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F82-3 (+B) - Body ground | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F80 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F80-22 (BLW) - F82-2 (SI) | Always | Below 1 Ω |
| F80-22 (BLW) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Reconnect the F82 blower motor with fan sub-assembly connector.
| *a | Front view of wire harness connector
(to Air Conditioning Amplifier Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F80-22 (BLW) - Body ground | Always | 4.5 to 5.5 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Reconnect the F80 air conditioning amplifier assembly connector.
Turn the ignition switch to ON.
Turn the blower switch on (LO).
| *a | Component with harness connected
(Air Conditioning Amplifier Assembly) |
Measure the waveform between terminal F80-22 (BLW) of the air conditioning amplifier assembly and body ground.
Waveform is similar to that shown in the illustration.
The waveform varies with the blower speed.
| Item | Content |
|---|---|
| Tool Setting | 1 V/DIV., 500 μs./DIV. |
| Vehicle Condition | ·
Ignition switch ON ·
Blower switch: LO |
| Proceed to |
|---|
| OK |
| NG |
OK
NG