Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)
RM3160E _58 Vehicle Interior _019714 HEATING / AIR CONDITIONING _0109952 AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)  IG Power Source Circuit  


DESCRIPTION

Power source voltage is supplied to the air conditioning amplifier assembly when the Ignition switch is ON. This power is used for operating the air conditioning amplifier assembly, servo motors, etc.

WIRING DIAGRAM

E285452E01
1.427,0.906 3.26,1.104 1.833,0.198 10 false from Battery 0.688,1.885 2.219,2.677 1.531,0.792 10 false from Ignition Switch*1 or Certification ECU (Smart Key ECU Assembly)*2 2.854,2.24 4.688,2.438 1.833,0.198 10 false IG1 NO. 2 0.615,3.938 3.156,4.354 2.542,0.417 10 false *1: w/o Smart Entry and Start System 0.615,4.25 3.156,4.667 2.542,0.417 10 false *2: w/ Smart Entry and Start System 4.302,1.073 6.135,1.271 1.833,0.198 10 false ECU-IG 5.594,0.927 6.24,1.208 0.646,0.281 10 false F80 5.594,2.177 6.24,2.458 0.646,0.281 10 false F80 5.604,2.885 6.25,3.167 0.646,0.281 10 false F81 5.625,2.677 6.271,2.958 0.646,0.281 10 false 24 5.635,1.979 6.281,2.26 0.646,0.281 10 false 14 5.667,0.719 6.313,1 0.646,0.281 10 false 1 6.021,0.927 6.667,1.208 0.646,0.281 10 false IG+ 6.01,2.188 6.656,2.469 0.646,0.281 10 false GND 6.021,2.885 6.667,3.167 0.646,0.281 10 false GND2 5.5,3.771 7.052,4.188 1.552,0.417 10 false Air Conditioning Amplifier Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - IG POWER SOURCE)
a.

Disconnect the F80 and F81 air conditioning amplifier assembly connectors.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F80-1 (IG+) - Body ground Ignition switch off Below 1 V
F80-1 (IG+) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F80-14 (GND) - Body ground Always Below 1 Ω
F81-24 (GND2) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR