Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)
RM3160E _58 Vehicle Interior _019714 HEATING / AIR CONDITIONING _0109952 AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)  Back-up Power Source Circuit  


DESCRIPTION

The back-up power source circuit for the air conditioning amplifier assembly is shown below. Power is supplied even when the ignition switch is off. This power is used for diagnostic trouble code memory, etc.

WIRING DIAGRAM

E285453E01
1.156,0.646 2.99,0.844 1.833,0.198 10 false from Battery 3.438,0.823 5.271,1.021 1.833,0.198 10 false A/C 5.594,3.771 7.156,4.198 1.563,0.427 10 false Air Conditioning Amplifier Assembly 5.604,0.667 6.063,0.865 0.458,0.198 10 false F80 5.583,2.177 6.042,2.375 0.458,0.198 10 false F80 5.594,1.365 6.052,1.563 0.458,0.198 10 false F81 5.583,2.885 6.042,3.083 0.458,0.198 10 false F81 5.635,2.688 6.094,2.885 0.458,0.198 10 false 24 5.635,1.979 6.094,2.177 0.458,0.198 10 false 14 5.635,1.167 6.094,1.365 0.458,0.198 10 false 28 5.635,0.458 6.094,0.656 0.458,0.198 10 false 21 6.01,0.656 6.469,0.854 0.458,0.198 10 false B 6.021,1.365 6.479,1.563 0.458,0.198 10 false +B2 6.021,2.167 6.479,2.365 0.458,0.198 10 false GND 6.021,2.885 6.479,3.083 0.458,0.198 10 false GND2

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - POWER SOURCE)
a.

Disconnect the F80 and F81 air conditioning amplifier assembly connectors.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F80-21 (B) - Body ground Always 11 to 14 V
F81-28 (+B2) - Body ground Always 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F80-14 (GND) - Body ground Always Below 1 Ω
F81-24 (GND2) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR