Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL OIL
RM3160E _52 Drivetrain _019687 AXLE AND DIFFERENTIAL _0109980 DIFFERENTIAL OIL A

AXLE AND DIFFERENTIAL  DIFFERENTIAL OIL  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:

Stop the vehicle on a level surface.


PROCEDURE

Hide 1.DRAIN DIFFERENTIAL OIL

a.
C201206

Using a 10 mm hexagon wrench, remove the differential inspection plug and gasket.


b.
C201207

Using a 10 mm hexagon wrench, remove the rear differential drain plug and gasket to drain the differential oil.


Hide 41110D 2.INSTALL REAR DIFFERENTIAL DRAIN PLUG

a.
C201207

Using a 10 mm hexagon wrench, install a new gasket and the rear differential drain plug.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


Hide 3.ADD DIFFERENTIAL OIL

a.
C279600
1.219,0.99 1.531,1.188 0.313,0.198 10 *a
*a 0 to 5 mm (0 to 0.196 in.)


Add differential oil so that the oil level is between 0 to 5 mm (0 to 0.196 in.) from the bottom lip of the differential inspection plug opening.

Oil Type:

Toyota genuine differential gear oil LT 75W-85 GL-5 or equivalent


Standard Differential Oil Capacity:

0.45 to 0.55 liters (0.48 to 0.58 US qts., 0.40 to 0.48 Imp.qts.)


NOTICE:
·

Too much or too little oil will lead to differential problems.

·

After changing the oil, drive the vehicle and then check the oil level again.




Hide 4.INSPECT DIFFERENTIAL OIL

a.
C279600
1.219,0.99 1.531,1.188 0.313,0.198 10 *a
*a 0 to 5 mm (0 to 0.196 in.)


Check that the oil level is between 0 to 5 mm (0 and 0.196 in.) from the bottom lip of the differential inspection plug opening.


b.

Inspect for oil leaks if the oil level is low.


Hide 41110X 5.INSTALL DIFFERENTIAL INSPECTION PLUG

a.
C201206

Using a 10 mm hexagon wrench, install a new gasket and the differential inspection plug.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)