Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019684 CRUISE CONTROL _0110063 LANE DEPARTURE ALERT SYSTEM J

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the lane departure warning camera.

WIRING DIAGRAM

E240004
0.385,0.708 1.365,1.156 0.979,0.448 10 false from IG1 NO. 2 Relay 3.031,0.854 3.844,1.073 0.813,0.219 10 false ECU-IG 5,0.698 5.479,0.979 0.479,0.281 10 false IGB 4.99,1.604 5.448,1.823 0.458,0.219 10 false GND 4.771,0.594 4.938,0.74 0.167,0.146 10 false 7 4.74,1.479 4.927,1.625 0.188,0.146 10 false 11 4.469,2.104 4.823,2.323 0.354,0.219 10 false S4 4.479,2.271 6.771,2.646 2.292,0.375 10 false Lane Departure Warning Camera

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK TERMINAL VOLTAGE (POWER SOURCE OF LANE DEPARTURE WARNING CAMERA)
a.
E255432
1.531,0.167 1.865,0.417 0.333,0.25 1.219,1.802 1.333,1.417 false 2.073,1.792 1.948,1.417 false 0.052,0.031 0.365,0.188 0.313,0.156 10 false *a 1.625,0.208 1.938,0.406 0.313,0.198 10 false S4 1.125,1.833 1.583,2.031 0.458,0.198 10 false IGB 1.979,1.833 2.438,2.031 0.458,0.198 10 false GND
*a Front view of wire harness connector
(to Lane Departure Warning Camera)


Disconnect the S4 lane departure warning camera connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
S4-7 (IGB) - Body ground Engine switch on (IG) 11 to 14 V
S4-7 (IGB) - Body ground Engine switch off Below 1 V


Standard Resistance:
Tester Connection Condition Specified Condition
S4-11 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (LANE DEPARTURE WARNING CAMERA - BATTERY AND BODY GROUND)