These DTCs are stored when a communication malfunction occurs between the sensors and ECUs.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0101 | Lost Communication with TCM | ·
2 seconds or more have elapsed after the engine switch is turned on (IG). ·
IG voltage is 10 V or more. ·
IG voltage is 10 V or more for 2 seconds or more. ·
While the vehicle is being driven at 1 km/h or 1 mph or more, communication between the ECM and lane departure warning camera stops for 5 seconds or more. |
·
CAN communication system ·
ECM ·
Lane departure warning camera |
| U0123 | Lost Communication with Yaw Rate Sensor Module | ·
2 seconds or more have elapsed after the engine switch is turned on (IG). ·
IG voltage is 10 V or more. ·
IG voltage is 10 V or more for 2 seconds or more. ·
While the vehicle is being driven at 1 km/h or 1 mph or more, communication between the yaw rate sensor and lane departure warning camera stops for 5 seconds or more. |
·
CAN communication system ·
Yaw rate sensor (airbag sensor assembly) ·
Lane departure warning camera |
| U0129 | Lost Communication with Brake System Control Module | ·
2 seconds or more have elapsed after the engine switch is turned on (IG). ·
IG voltage is 10 V or more. ·
IG voltage is 10 V or more for 2 seconds or more. ·
While the engine switch is on (IG), communication between the skid control ECU and lane departure warning camera stops for 5 seconds or more. |
·
CAN communication system ·
Skid control ECU (brake actuator assembly) ·
Lane departure warning camera |
| U0142 | Lost Communication with Body Control Module "B" | ·
2 seconds or more have elapsed after the engine switch is turned on (IG). ·
IG voltage is 10 V or more. ·
IG voltage is 10 V or more for 2 seconds or more. ·
While the engine switch is on (IG), communication between the main body ECU and lane departure warning camera stops for 5 seconds or more. |
·
CAN communication system ·
Main body ECU (multiplex network body ECU) ·
Lane departure warning camera |
| U0155 | Lost Communication with Instrument Panel Cluster (IPC) Control Module (Combination Meter) | ·
2 seconds or more have elapsed after the engine switch is turned on (IG). ·
IG voltage is 10 V or more. ·
IG voltage is 10 V or more for 2 seconds or more. ·
While the engine switch is on (IG), communication between the combination meter and lane departure warning camera stops for 50 seconds or more. |
·
CAN communication system ·
Combination meter assembly ·
Lane departure warning camera |
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output | A |
| CAN communication system DTCs are output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING