Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019684 CRUISE CONTROL _0110870 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  Cruise Main Indicator Light Circuit  


DESCRIPTION

When the dynamic radar cruise control system is turned on using the cruise control main switch (ON-OFF button), the cruise control indicator (vehicle-to-vehicle distance control mode) or cruise control indicator (constant speed control mode) illuminates. The driving support ECU assembly uses this and other indicators to indicate the control condition (presence or absence of a vehicle in front, vehicle-to-vehicle distance, and set speed) and fail-safe state via CAN communication.

HINT:

If the preceding vehicle in the same lane significantly decreases vehicle speed or another vehicle moves in front of this vehicle, adequate deceleration cannot be applied by the dynamic radar cruise control system and the vehicle-to-vehicle distance will become shorter. At this time, the system sounds the buzzer to warn the driver. The indicators for the dynamic radar cruise control system use CAN for communication. Therefore, if there are any indicator malfunctions, check for DTCs in the CAN communication system before troubleshooting this circuit.


WIRING DIAGRAM

E230248
0.844,2.271 2.594,2.625 1.75,0.354 10 false : CAN Communication Line 1.01,1.906 2.885,2.083 1.875,0.177 10 false Combination Meter Assembly 1.01,1.729 1.385,1.948 0.375,0.219 10 false F22 5.26,1.75 5.656,1.948 0.396,0.198 10 false A43 4.917,0.698 5.354,0.875 0.438,0.177 10 false CANH 4.927,1.198 5.365,1.417 0.438,0.219 10 false CANL 2.104,0.677 2.542,0.906 0.438,0.229 10 false CANH 2.104,1.188 2.542,1.417 0.438,0.229 10 false CANL 2.615,0.49 2.938,0.76 0.323,0.271 10 false 17 4.667,0.5 4.875,0.708 0.208,0.208 10 false 13 4.667,1.021 4.875,1.219 0.208,0.198 10 false 26 2.615,1.01 2.906,1.229 0.292,0.219 10 false 16 5.26,1.938 5.844,2.219 0.583,0.281 10 false ECM

PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (METER DISPLAY 1)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Cruise control indicator (Constant speed control mode)
Cruise control indicator (Vehicle-to-vehicle distance control mode)
OFF or All -
Body Electrical > Combination Meter > Active Test
Tester Display
Meter Display 1
50004 122 7

e.

Check the cruise control indicator by performing Active Test.

OK:

The display changes in accordance with Active Test operation.



Result:
Proceed to
OK
NG


f.

Turn the engine switch off.



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE COMBINATION METER ASSEMBLY