Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019684 CRUISE CONTROL _0110870 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  TC and CG Terminal Circuit  


DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the dynamic radar cruise control system to enter self-diagnostic mode. If a malfunction is present, the cruise control indicator will blink.

HINT:

When a particular warning light remains blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in the relevant ECU is suspected.


WIRING DIAGRAM

E259150
6.25,2.698 6.521,2.896 0.271,0.198 10 false A43 6.24,2.875 6.635,3.135 0.396,0.26 10 false ECM 0.583,2.688 0.875,2.885 0.292,0.198 10 false F25 0.583,2.865 1.115,3.063 0.531,0.198 10 false DLC3 5.781,0.792 6,0.958 0.219,0.167 10 false 45 1.26,0.771 1.479,0.938 0.219,0.167 10 false 13 6.01,0.896 6.281,1.063 0.271,0.167 10 false TC 0.99,0.885 1.26,1.052 0.271,0.167 10 false TC 1.25,1.677 1.469,1.844 0.219,0.167 10 false 4 0.958,1.792 1.229,1.958 0.271,0.167 10 false CG

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TERMINAL TC OF DLC3 - ECM)
a.

Disconnect the A43 ECM connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):
Tester Connection Condition Specified Condition
F25-13 (TC) - A43-45 (TC) Always Below 1 Ω


Standard Resistance (Check for Short):
Tester Connection Condition Specified Condition
F25-13 (TC) or A43-45 (TC) - Body ground Always 10 kΩ or higher



c.

Reconnect the A43 ECM connector.


Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (TERMINAL CG OF DLC3 - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (TERMINAL TC OF DLC3 - ECM)

2.CHECK HARNESS AND CONNECTOR (TERMINAL CG OF DLC3 - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):
Tester Connection Condition Specified Condition
F25-4 (CG) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (TERMINAL CG OF DLC3 - BODY GROUND)