Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019684 CRUISE CONTROL _0110870 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1616  Communication Error from ECM to Distance Control ECU  


DESCRIPTION

The ECM receives signals from each sensor and ECU, then sends signals such as A/T signals, cruise control operation signals, low speed operation signals, brake control operation signals, and radar beam emission prohibiting signals to the driving support ECU assembly. The ECM is the only component that has a function to store and output DTCs in the dynamic radar cruise control system. Therefore, if the driving support ECU assembly detects a communication error from the ECM, it sends a malfunction signal back to the ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area
P1616 Communication Error from ECM to Distance Control ECU While the dynamic radar cruise control is either preparing for operation or operating, the ECM continuously receives a logic error signal from the driving support ECU assembly for more than a certain amount of time, the ECM stores this DTC.
·

ECM

·

Driving support ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

The dynamic radar cruise control system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the dynamic radar cruise control system after confirming that the communication systems are functioning properly.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING


PROCEDURE

1.REPLACE ECM
a.

Replace the ECM with a new one.

Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>ECM>COMPONENTS


Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTCS (DTC P1616)
2.CHECK FOR DTCS (DTC P1616)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).



d.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed for which cruise control operation is possible.


ii.

Turn the cruise control main switch on.



e.

Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.


f.

Check for DTCs.

Powertrain > Radar Cruise > Trouble Codes
50001 239

Result:
Result Proceed to
DTCs are not output A
DTC P1616 is output B


g.

Turn the engine switch off.



A

END

B