In the dynamic radar cruise control system, the ECM and the driving support ECU assembly communicate with one another to control the system based on some designation information. If the designation information of the ECM and driving support ECU assembly is different or the driving support ECU assembly is malfunctioning, this DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P1617 | Distance Control ECU Malfunction | While the dynamic radar cruise control is either preparing for operation or operating, a designation signal from the ECM and a designation signal from the driving support ECU assembly do not match for more than a certain amount of time or the driving support ECU assembly is malfunctioning, the ECM stores this DTC. | ·
Driving support ECU assembly ·
ECM |
Replace the driving support ECU assembly.
Click hereEngine / Hybrid System>CRUISE CONTROL>DRIVING SUPPORT ECU(for RHD)>COMPONENTS
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).
Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC P1617 is output | B |
Turn the engine switch off.
A
B