Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2013.12–2016.11
RM3160E _58 Vehicle Interior _019711 PRE-CRASH SAFETY _0110871 PRE-CRASH SAFETY SYSTEM D

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  DIAGNOSIS SYSTEM  



FUNCTION OF WARNING INDICATOR AND MESSAGE


a.

If the pre-crash safety system is not functioning properly, the driver is warned by the PCS warning light and a warning message on the multi-information display in the combination meter assembly.

Master Warning Light Warning Message Detail DTC PCS Warning Light
ON Check PCS System This message is displayed when the driving support ECU assembly detects a system malfunction ○ Flashes
OFF PCS temporarily not available This message is displayed when the driving support ECU assembly is in fail-safe mode
Click here(Click here)
- Flashes


b.

Initial check

i.

The initial check occurs when the engine switch is off for more than 2 seconds, and then turned on (IG). The initial check consists of a pre-crash safety system diagnostic check with a duration of approximately 3 seconds.


ii.

If a malfunction is detected during the initial check, the multi-information display will display "Check PCS System " or "PCS temporarily not available".



c.

Constant check

i.

The driving support ECU assembly constantly monitors the pre-crash safety system for malfunctions after the engine switch is turned on (IG) and the initial check (approximately 3 seconds) has completed.


ii.

"Check PCS System" or "PCS temporarily not available" is displayed on the multi-information display in the combination meter assembly when the constant check detects malfunctions in the pre-crash safety system.