Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2013.12–2016.11
RM3160E _58 Vehicle Interior _019711 PRE-CRASH SAFETY _0110871 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  U0125  Lost Communication with Yaw Rate Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  U0142  Lost Communication with Body Control Module "B"  U1002  Lost Communication with Gateway Module  U1104  Lost Communication with Driving Support ECU  


DESCRIPTION

The driving support ECU assembly uses the millimeter wave radar sensor assembly to detect obstacles in front of the vehicle. Based on this information, the driving support ECU assembly sends pre-crash safety control operation signals. These DTCs are stored when a communication malfunction occurs between the sensors and ECUs that detect crashes, or between ECUs that perform the pre-crash safety control.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0125 Lost Communication with Yaw Rate Sensor Module When the engine switch is on (IG), a communication error between the airbag sensor assembly (yaw rate sensor) and the driving support ECU assembly is detected for approximately 1 second.
·

CAN communication system

·

Airbag sensor assembly

·

Driving support ECU assembly


U0126 Lost Communication with Steering Angle Sensor Module When the engine switch is on (IG), a communication error between the steering sensor and the driving support ECU assembly is detected for approximately 4 seconds.
·

CAN communication system

·

Steering sensor

·

Driving support ECU assembly


U0129 Lost Communication with Brake System Control Module When the engine switch is on (IG), a communication error between the skid control ECU (brake actuator assembly) and the driving support ECU assembly is detected for approximately 3 seconds.
·

CAN communication system

·

Skid control ECU (brake actuator assembly)

·

Driving support ECU assembly


U0142 Lost Communication with Body Control Module "B" When the engine switch is on (IG), a communication error between the main body ECU (multiplex network body ECU) and driving support ECU assembly is detected for approximately 14.2 seconds.
·

CAN communication system

·

Main body ECU (multiplex network body ECU)

·

Driving support ECU assembly


U1002 Lost Communication with Gateway Module When the engine switch is on (IG), a communication error between the millimeter wave radar sensor assembly and driving support ECU assembly is detected for approximately 0.5 seconds.
·

CAN communication system

·

Millimeter wave radar sensor assembly

·

Driving support ECU assembly


U1104 Lost Communication with Driving Support ECU When the engine switch is on (IG), a communication error between the ECM or brake actuator assembly (skid control ECU) and the driving support ECU assembly is detected for approximately 1 second.
·

CAN communication system

·

ECM

·

Brake actuator assembly (skid control ECU)

·

Driving support ECU assembly



PROCEDURE

1.CHECK FOR DTC (PRE-CRASH 2)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).



d.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



e.

Check the DTCs.

Body Electrical > Pre-Crash 2 > Trouble Codes
50001 220

Result:
Result Proceed to
CAN communication system DTCs are not output A
CAN communication system DTCs are output B


f.

Turn the engine switch off.



A

B