The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation receiver assembly via this circuit.
Disconnect the F119 navigation receiver assembly connector.
Disconnect the F125 No. 1 stereo jack adapter assembly connector.
| *a | Front view of wire harness connector
(to Navigation Receiver Assembly) |
| *b | Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F125-2 (US1-) - F119-2 (US1-) | Always | Below 1 Ω |
| F125-3 (US1+) - F119-3 (US1+) | Always | Below 1 Ω |
| F125-5 (USG1) - F119-5 (USG1) | Always | Below 1 Ω |
| F125-2 (US1-) - Body ground | Always | 10 kΩ or higher |
| F125-3 (US1+) - Body ground | Always | 10 kΩ or higher |
| F125-5 (USG1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG