Home › Engine / Hybrid System › 1AR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › from 2015.11
RM3160E _51 Engine / Hybrid System _019671 1AR-FE ENGINE CONTROL _0106855 CRANKSHAFT POSITION SENSOR A

1AR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.


b.

Install the crankshaft position sensor to the timing chain cover sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the crankshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.




c.

Connect the crankshaft position sensor connector.


Hide 53736 3.INSTALL FRONT FENDER APRON SEAL RH