84650
1.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (w/ Auto Wiper System)
Check the front washer operation (for LHD).
| *a | Component with harness connected
(Windshield Wiper Switch Assembly) |
Connect a voltmeter positive (+) lead to terminal F64-3 (+1) and a negative (-) lead to terminal F65-4 (EW).
Turn the ignition switch to ON.
Turn the washer switch on and off, and check the voltage between terminals F64-3 (+1) and F65-4 (EW).
Voltage changes as shown in the illustration.
If the result is not as specified, replace the windshield wiper switch assembly.
Check the front washer operation (for RHD).
| *a | Component with harness connected
(Windshield Wiper Switch Assembly) |
Connect a voltmeter positive (+) lead to terminal F64-2 (+1) and a negative (-) lead to terminal F65-4 (EW).
Turn the ignition switch to ON.
Turn the washer switch on and off, and check the voltage between terminals F64-2 (+1) and F65-4 (EW).
Voltage changes as shown in the illustration.
If the result is not as specified, replace the windshield wiper switch assembly.
84650
2.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (w/o Auto Wiper System)
Check the front wiper intermittent operation (for LHD).
| *a | Component with harness connected
(Windshield Wiper Switch Assembly) |
Connect a voltmeter positive (+) lead to terminal F64-3 (+1) and a negative (-) lead to terminal F65-4 (EW).
Turn the wiper switch to the INT position.
Operate the intermittent wiper and check the voltage between terminals F64-3 (+1) and F65-4 (EW).
Voltage changes as shown in the illustration.
If the result is not as specified, replace the windshield wiper switch assembly.
Check the front washer operation (for LHD).
| *a | Component with harness connected
(Windshield Wiper Switch Assembly) |
Connect a voltmeter positive (+) lead to terminal F64-3 (+1) and a negative (-) lead to terminal F65-4 (EW).
Turn the ignition switch to ON.
Turn the washer switch on and off, and check the voltage between terminals F64-3 (+1) and F65-4 (EW).
Voltage changes as shown in the following illustration.
If the result is not as specified, replace the windshield wiper switch assembly.
Check the front wiper intermittent operation (for RHD).
| *a | Component with harness connected
(Windshield Wiper Switch Assembly) |
Connect a voltmeter positive (+) lead to terminal F64-2 (+1) and a negative (-) lead to terminal F65-7 (EW).
Turn the wiper switch to the INT position.
Operate the intermittent wiper and check the voltage between terminals F64-2 (+1) and F65-7 (EW).
Voltage changes as shown in the illustration.
If the result is not as specified, replace the windshield wiper switch assembly.
Check the front washer operation (for RHD).
| *a | Component with harness connected
(Windshield Wiper Switch Assembly) |
Connect a voltmeter positive (+) lead to terminal F64-2 (+1) and a negative (-) lead to terminal F65-7 (EW).
Turn the ignition switch to ON.
Turn the washer switch on and off, and check the voltage between terminals F64-2 (+1) and F65-7 (EW).
Voltage changes as shown in the following illustration.
If the result is not as specified, replace the windshield wiper switch assembly.