Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR(When Not Using the Engine Support Bridge for AWD) › from 2016.11
RM3160E _55 Steering _019699 STEERING GEAR / LINKAGE _0295272 STEERING GEAR(When Not Using the Engine Support Bridge for AWD) G

STEERING GEAR / LINKAGE  STEERING GEAR(When Not Using the Engine Support Bridge for AWD)  INSPECTION  


PROCEDURE

Hide 45470 1.INSPECT TIE ROD ASSEMBLY LH

a.
ZK08184

Secure the tie rod assembly LH in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Install the nut to the stud bolt.


c.

Flip the ball joint back and forth 5 times.


d.

Using a torque wrench and the nut, turn the stud continuously at a rate of 2 to 4 seconds per turn, and check the turning torque on the 5th turn.

Standard Turning Torque:

0.49 to 3.43 N*m (5 to 34 kgf*cm, 5 to 30 in.*lbf)


HINT:

If the turning torque is not within the specified range, replace the tie rod assembly LH with a new one.



e.

Check that the ball joint dust cover is not cracked and that there is no grease on it.

HINT:

If the ball joint dust cover is cracked or there is grease on it, replace the tie rod assembly LH with a new one.



Hide 45460 2.INSPECT TIE ROD ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 3.INSPECT TOTAL PRELOAD

NOTICE:

Inspect the total preload in a no-load condition by removing the tie rod assemblies RH and LH.


a.
C293554N01
2.302,0.896 2.542,0.896 false 2.594,0.813 3.052,1.01 0.458,0.198 10 false SST

Install SST to the pinion shaft and turn it left and right 5 times or more.

SST
09616-00011  


b.

Using a torque wrench and SST, turn the pinion shaft continuously at a rate of 4 to 6 seconds per turn to inspect the total preload of the steering gear assembly.

Standard Preload:

0.75 to 1.35 N*m (8 to 13 kgf*cm, 7 to 11 in.*lbf)


NOTICE:

Inspect the total preload around the steering rack center position.


HINT:

If the total preload is not within the specified range, replace the steering gear assembly with a new one.