1.INSPECT COOLER COMPRESSOR ASSEMBLY (COMPRESSOR SOLENOID)
| *a | Component without harness connected
(Cooler Compressor Assembly (Compressor Solenoid)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (SOL-) - 2 (SOL+) | 25°C (77°F) | 10.1 to 11.1 Ω |
If the resistance is not as specified, replace the cooler compressor assembly.
2.INSPECT COOLER COMPRESSOR ASSEMBLY (A/C LOCK SENSOR)
| *a | Component without harness connected
(Cooler Compressor Assembly (A/C Lock Sensor)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (SSR+) - 2 (SSR-) | 20°C (68°F) | 160 to 320 Ω |
If the resistance is not as specified, replace the cooler compressor assembly.
3.INSPECT COOLER COMPRESSOR ASSEMBLY (MAGNETIC CLUTCH ASSEMBLY)
| *a | Component without harness connected
(Cooler Compressor Assembly (Magnetic Clutch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (MG+) - Body ground | 20°C (68°F) | 3.8 to 4.2 Ω |
Connect a positive (+) lead from the battery to terminal 3 (MG+) and check that the following occurs: 1) the magnetic clutch assembly operating sound can be heard, and 2) the magnetic clutch hub and rotor lock.
If the result is not as specified, replace the magnetic clutch assembly.