Home › Steering › STEERING COLUMN › STEERING PAD SWITCH › from 2016.11
RM3160E _55 Steering _019698 STEERING COLUMN _0101110 STEERING PAD SWITCH G

STEERING COLUMN  STEERING PAD SWITCH  INSPECTION  


PROCEDURE

Hide 84250A 1.INSPECT STEERING PAD SWITCH ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

E352459C01
4.979,0.396 5.281,0.573 0.302,0.177 2.042,0.5 2.313,0.698 0.271,0.198 2.406,2.042 2.948,2.208 false 2.354,1.771 2.917,1.531 false 5.521,2.667 5.188,2.365 false 4.969,2.99 4.896,2.438 false 4.125,2.385 4.906,2.073 false 5.854,2.104 5.271,2.073 false 5.115,1.896 5.667,1.813 false 5.271,1.729 5.688,1.313 false 4.125,1.76 4.719,1.885 false 4.938,1.719 5.073,1.292 false 1.542,2.792 1.958,2.375 false 1.865,1.75 1.5,1.573 false 1.313,2.031 1.854,1.969 false 1.51,2.365 2.083,2.073 false 2.094,1.75 2.177,1.177 false 2.188,2.875 2.219,2.417 false 4.948,1.875 5.365,1.25 false 0.177,0.083 0.49,0.24 0.313,0.156 10 false *a 1.365,1.438 1.677,1.594 0.313,0.156 10 false *b 1.156,1.938 1.469,2.094 0.313,0.156 10 false *c 2.115,1.01 2.427,1.167 0.313,0.156 10 false *d 1.354,2.302 1.667,2.458 0.313,0.156 10 false *e 2.958,1.438 3.271,1.594 0.313,0.156 10 false *f 1.396,2.729 1.635,3.01 0.24,0.281 10 false *g 2.115,2.906 2.427,3.063 0.313,0.156 10 false *h 2.99,2.146 3.229,2.333 0.24,0.188 10 false *i 5.042,1.073 5.24,1.354 0.198,0.281 10 false *j 3.958,2.323 4.167,2.542 0.208,0.219 10 false *k 4,1.667 4.219,1.854 0.219,0.188 10 false *l 5.719,1.708 6.031,1.865 0.313,0.156 10 false *m 5.344,1.083 5.635,1.292 0.292,0.208 10 false *n 5.677,1.177 5.979,1.448 0.302,0.271 10 false *o 5.573,2.635 6.208,2.875 0.635,0.24 10 false *p (*A) 5.896,2.01 6.146,2.24 0.25,0.229 10 false *q 4.865,2.99 5.521,3.292 0.656,0.302 10 false *r (*A) 2.135,0.521 2.448,0.677 0.313,0.156 10 false B 5.083,0.406 5.396,0.563 0.313,0.156 10 false A
*A w/ Dynamic Radar Cruise Control System - -
*a Component without harness connected
(Steering Pad Switch Assembly)
*b Volume+
*c Volume- *d Seek+
*e Seek- *f MODE/HOLD
*g Off Hook *h On Hook
*i Voice *j Up
*k Down *l Left
*m Right *n Enter
*o Back *p Distance Control
*q Top *r Lane Departure Alert


Standard Resistance:
Tester Connection Condition Specified Condition
A-11 - A-8 No switch pushed 95 to 105 kΩ
SEEK+ switch pushed Below 2.5 Ω
SEEK- switch pushed 313 to 345 Ω
Volume+ switch pushed 950 to 1050 Ω
Volume- switch pushed 2955 to 3265 Ω
A-10 - A-8 No switch pushed 95 to 105 kΩ
MODE/HOLD switch pushed Below 2.5 Ω
On hook switch pushed 313 to 345 Ω
Off hook switch pushed 950 to 1050 Ω
Voice switch pushed 2955 to 3265 Ω
A-3 - A-8 No switch pushed 95 to 105 kΩ
Left switch pushed Below 2.5 Ω
Up switch pushed 313 to 345 Ω
Down switch pushed 950 to 1050 Ω
Right switch pushed 2955 to 3265 Ω
A-2 - A-8 No switch pushed 95 to 105 kΩ
Enter switch pushed Below 2.5 Ω
Top switch pushed 313 to 345 Ω
Back switch pushed 950 to 1050 Ω
A-4 - A-7* No switch pushed 1 MΩ or higher
Distance control switch pushed Below 2.5 Ω
Lane departure alert switch pushed 228 to 252 Ω
A-5 - B-1 Always Below 2.5 Ω


*: w/ Dynamic Radar Cruise Control System


HINT:

If the result is not as specified, replace the steering pad switch assembly.



b.

Check the illumination.

E352460C01
0.292,0.167 0.604,0.365 0.313,0.198 10 false *a
*a Component without harness connected
(Steering Pad Switch Assembly)
- -


i.

Connect a positive (+) lead from the battery to terminal 1 and a negative (-) lead to terminal 9 of the steering pad switch assembly connector.


ii.

Check that the steering pad switch assembly illumination illuminates.

OK:

The steering pad switch assembly illumination illuminates.


HINT:

If the result is not as specified, replace the steering pad switch assembly.