The ECM illuminates the cruise control SET indicator by sending indicator output demand signals to the combination meter assembly via CAN communication. The cruise control SET indicator illuminates when the cruise control system is controlling vehicle speed. The cruise SET indicator light circuit uses CAN communication. If the cruise control SET indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.
Observe the following items for safety reasons when using the GTS:
Before using the GTS, read the instruction manual.
Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.
When driving the vehicle for testing purposes, 2 people are required. One person should operate the GTS while the other drives the vehicle.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Check the cruise control SET indicator by performing the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Meter Display 1 | Multi-information display | OFF or All | Test possible at vehicle speed of 0 km/h (0 mph) |
| Tester Display |
|---|
| Meter Display 1 |
| Result | Proceed to |
|---|---|
| The multi-information display in the combination meter assembly turns on or off according to the operation of the Active Test. | A |
| The multi-information display in the combination meter assembly does not turn on or off according to the operation of the Active Test. | B |
A
B
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Turn the cruise control system on using the cruise control main switch (ON-OFF button).
Drive at a speed between approximately 40 km/h (25 mph) and 200 km/h (124 mph).
Enter the following menus: Powertrain / Cruise Control*1 or Radar Cruise 1*2 / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| SET/COAST Switch | -SET switch status | ON or OFF | ON: -SET switch on
OFF: -SET switch off |
- |
| Tester Display |
|---|
| SET/COAST Switch |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| -SET Switch | -SET switch status | ON or OFF | ON: -SET switch on
OFF: -SET switch off |
- |
| Tester Display |
|---|
| -SET Switch |
*1: for 1AR-FE
*2: for 2GR-FKS
| Result | Proceed to |
|---|---|
| The cruise control SET indicator illuminates and turns off according to the operation of the cruise control main switch (-SET switch). | A |
| The cruise control SET indicator does not illuminate but the Data List item -SET Switch changes according to the operation of the cruise control main switch (-SET switch). | B |
| The cruise control SET indicator does not illuminate and the Data List item -SET Switch does not change according to the operation of the cruise control main switch (-SET switch). | C |
A
B
C
for 1AR-FE: Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>ECM>COMPONENTS
for 2GR-FKS: Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>ECM>COMPONENTS