Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 1AR-FE) › from 2016.11
RM3160E _51 Engine / Hybrid System _019684 CRUISE CONTROL _0296315 DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 1AR-FE) J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 1AR-FE)  Cruise SET Indicator Light Circuit  


DESCRIPTION

The ECM illuminates the cruise control SET indicator by sending indicator output demand signals to the combination meter assembly via CAN communication. The cruise control SET indicator illuminates when the dynamic radar cruise control system is controlling vehicle speed. The cruise SET indicator light circuit uses CAN communication. If the cruise control SET indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

CAUTION / NOTICE / HINT

CAUTION:

Observe the following items for safety reasons when using GTS:

·

Before using the GTS, read the instruction manual.

·

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes, 2 people are required. One person should operate the GTS while the other drives the vehicle.



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform "Active Test" according to the display on the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF or All Test possible at vehicle speed of 0 km/h (0 mph)
Body Electrical > Combination Meter > Active Test
Tester Display
Meter Display 1
50004 122 7
Result:
Result Proceed to
The multi-information display in the combination meter assembly turns on or off according to the operation of the Active Test. A
The multi-information display in the combination meter assembly does not turn on or off according to the operation of the Active Test. B




A

2.READ VALUE USING GTS

B

2.READ VALUE USING GTS
a.

Turn the cruise control system on using the cruise control main switch (ON-OFF button).


b.

Drive at a speed between approximately 40 km/h (25 mph) and 180 km/h (112 mph).


c.

Enter the following menus: Powertrain / Radar Cruise 1 / Data List.


d.

Read the Data List according to the display on the GTS.

Powertrain > Radar Cruise1 > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
-SET Switch -SET switch signal ON or OFF ON: -SET switch on
OFF: -SET switch off
-
Powertrain > Radar Cruise1 > Data List
Tester Display
-SET Switch
50003 239 116
Result:
Result Proceed to
The cruise control SET indicator illuminates and turns off according to the operation of the cruise control main switch (-SET switch). A
The cruise control SET indicator does not illuminate but the Data List item -SET Switch changes according to the operation of the cruise control main switch (-SET switch). B
The cruise control SET indicator does not illuminate and the Data List item -SET Switch does not change according to the operation of the cruise control main switch (-SET switch). C




A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C