This DTC is stored when there is a malfunction in the ECM.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P0575 | Cruise Control Input Circuit | ·
While the dynamic radar cruise control system is operating, the dynamic radar cruise control system control of vehicle speed is not canceled and approximately 0.4 seconds have elapsed after cruise cancel signal (STP signal) is received by the ECM. ·
When the engine switch is on (IG), STP signals received by the ECM supervisory CPU and that received by the control ECU do not match for approximately 0.2 seconds or more. |
ECM |
The ECM receives signals from each sensor to control all functions of the cruise control system. When a malfunction is detected, the fail-safe function operates until the engine switch is turned off.
Clear the DTCs.
Perform the following to make sure that the DTC detection conditions are met.
If the following conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which dynamic radar cruise control operation is possible.
Turn the cruise control system on using the cruise control main switch (ON-OFF button).
Depress the brake pedal for 0.4 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC P0575 is not output. | A |
| DTC P0575 is output. | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B