The ECM receives signals from the skid control ECU (brake actuator assembly) via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U012287 | Lost Communication with Vehicle Dynamics Control Module Missing Message | While the vehicle speed is 40 km/h (25 mph) or more and the cruise control main switch (ON-OFF button) is on, signals cannot be received from the skid control ECU (brake actuator assembly) for 2.65 seconds or more. | ·
CAN communication system ·
ECM ·
Skid control ECU (brake actuator assembly) |
Refer to troubleshooting in CAN Communication System.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Perform the following to make sure that the DTC detection conditions are met.
If the following conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the cruise control main switch (ON-OFF button).
Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC U012287 is not output | A |
| DTC U012287 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING