Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2016.11
RM3160E _53 Suspension _060167 TIRE PRESSURE MONITORING _0296404 TIRE PRESSURE WARNING SYSTEM J

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  ECU Power Source Circuit  


DESCRIPTION

The IG circuit is the power source for the tire pressure warning ECU and receiver.

WIRING DIAGRAM

C270968E55
4.958,1.802 5.448,2.073 0.49,0.271 10 false M45 4.958,1.979 6.375,2.573 1.417,0.594 10 false Tire Pressure Warning ECU and Receiver 5.031,0.615 5.25,0.875 0.219,0.26 10 false IG 5.031,1.156 5.406,1.365 0.375,0.208 10 false GND 4.833,0.51 4.979,0.76 0.146,0.25 10 false 1 4.771,1.042 4.958,1.26 0.188,0.219 10 false 12 3.292,0.823 4.344,1.073 1.052,0.25 10 false IG1 NO. 3 0.938,0.635 1.896,0.875 0.958,0.24 10 false from IG Circuit

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initializationSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION after registrationSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



HINT:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ECU - BATTERY AND BODY GROUND)
a.
C361354C04
0.333,0.833 0.75,1.083 0.417,0.25 0.75,1.583 0.917,1.583 0.917,1.583 1.24,1.26 true 2.719,1.719 2.552,1.719 2.552,1.719 2.219,1.469 true 0.396,0.854 0.854,1.052 0.458,0.198 10 false M45 0.552,1.5 0.833,1.75 0.281,0.25 10 false IG 2.802,1.635 3.26,1.833 0.458,0.198 10 false GND 0.073,0.073 0.385,0.271 0.313,0.198 10 false *a
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)


Disconnect the M45 tire pressure warning ECU and receiver connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
M45-1 (IG) - Body ground Engine switch on (IG) 10 to 16 V
Engine switch off Below 1 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
M45-12 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR