MALFUNCTION DISPLAY (MULTI-INFORMATION DISPLAY)
Open circuit indication
If there is an open circuit between a No. 1 ultrasonic sensor and the clearance warning ECU assembly or a sensor is malfunctioning, the malfunction is displayed as shown in the illustration.
If a sensor has an open circuit, check for DTCs and troubleshoot according to each inspection procedure.
Frozen indication
If a sensor is covered with foreign matter, such as mud or snow, the affected sensor is displayed as shown in the illustration.
If a frozen indication is displayed, read Precaution for Toyota parking assist-sensor system first and confirm that the sensor is not covered with foreign matter.
Check for DTCs and troubleshoot according to each inspection procedure after confirming that the sensor is not covered with foreign matter.
MALFUNCTION DISPLAY (MULTI-DISPLAY)
Open circuit indication
If there is an open circuit between the No. 1 ultrasonic sensor and the clearance warning ECU assembly or a sensor is malfunctioning, the malfunction is displayed as shown in the illustration.
| *A | for RHD | *B | for LHD |
| *a | When panoramic view monitor system (When panoramic view screen is displayed) operates | *b | When panoramic view monitor system (panoramic view screen not displayed) operates |
| *c | When full screen is displayed | *c | Example |
If a sensor has an open circuit, check for DTCs and troubleshoot according to each inspection procedure.
Frozen indication
If a sensor is covered with foreign matter, such as mud or snow, the affected sensor is displayed as shown in the illustration.
| *A | for RHD | *B | for LHD |
| *a | When panoramic view monitor system (When panoramic view screen is displayed) operates | *b | When panoramic view monitor system (panoramic view screen not displayed) operates |
| *c | When full screen is displayed | *c | Example |
If a frozen indication is displayed, read Precaution for Toyota parking assist-sensor system first and confirm that the sensor is not covered with foreign matter.
Check for DTCs and troubleshoot according to each inspection procedure after confirming that the sensor is not covered with foreign matter.
DETECTION RANGE MEASUREMENT AND DISPLAY INSPECTION
The following measurement and inspection will be performed with the shift lever in a position other than P. Be sure to apply the parking lever and depress the brake pedal firmly to prevent the vehicle from moving.
Turn the ignition switch to ON.
Turn the back sonar or clearance sonar switch assembly on.
Detection range measurement:
Move the shift lever according to the table below.
| Measurement Area | Shift Lever Position |
| Front Corner | In any position other than P |
| Rear Corner | R |
| Rear Center |
Move a 60 mm (2.36 in.) diameter pole near each sensor to measure its detection range. When measuring the longest-range detection of rear center sonar, use a wall or equivalent.
These detection ranges are applicable when positioning the 60 mm (2.36 in.) diameter pole parallel or perpendicular to the ground. The detection range varies depending on the measuring method and type of obstacle (such as walls).
Have an assistant move the pole.
The No. 1 ultrasonic sensor side view detection range (hatched area labeled (B)) represents the cross section of the top view detection range (A). The hatched area (B) does not represent the entire side view detection range.
Front center sonar display and buzzer operation check
When the No. 1 ultrasonic sensors (front corner sonar) have detected an obstacle, check the display and check that the buzzer sounds.
| Ignition Switch | Back Sonar or Clearance Sonar Switch Assembly | Shift Lever Position | Vehicle Speed |
|---|---|---|---|
| ON | On | In any position other than P or R | Less than approximately 10 km/h (6 mph) |
| ON | On | R | - |
| *A | for RHD | *B | for LHD |
| *a | Multi-information Display | *b | Multi-display |
| *c | Example (Front Corner Sonar) | *d | Close-range Detection |
| *e | Medium-range Detection | *f | Long-range Detection |
| *g | When panoramic view monitor system (When panoramic view screen is displayed) operates | *h | When panoramic view monitor system (panoramic view screen not displayed) operates |
| *i | When full screen is displayed | - | - |
| Detection Range | During Judgment | Obstacle |
|---|---|---|
| Close-range detection
Within approx. 300 +/- 50 mm (11.8 +/- 2.0 in.) |
Buzzer: Sounds continuously
Number of bars displayed: 1 (blinking) |
60 mm (2.36 in.) diameter pole |
| Medium-range detection
From approx. 300 +/- 50 to 450 +/- 50 mm (11.8 +/- 2.0 to 17.7 +/- 2.0 in.) |
Buzzer: Sounds intermittently (ON: 0.075 sec. / OFF: 0.075 sec.)
Number of bars displayed: 2 (illuminated) |
60 mm (2.36 in.) diameter pole |
| Long-range detection
From approx. 450 +/- 50 to 600 +/- 50 mm (17.7 +/- 2.0 to 23.6 +/- 2.0 in.) |
Buzzer: Sounds intermittently (ON: 0.15 sec. / OFF: 0.15 sec.)
Number of bars displayed: 3 (illuminated) |
60 mm (2.36 in.) diameter pole |
Ultrasonic waves are used to measure the detection range; however, the detection range may vary depending on the ambient temperature.
Rear corner sonar display and buzzer operation check
When the No. 1 ultrasonic sensors (rear corner sonar) have detected an obstacle, check the display and check that the buzzer sounds.
| Ignition Switch | Back Sonar or Clearance Sonar Switch Assembly | Shift Lever Position | Vehicle Speed |
|---|---|---|---|
| ON | On | R | - |
| *a | Multi-information Display | *b | Multi-display |
| *c | Example (Rear Corner Sonar) | *d | Close-range Detection |
| *e | Medium-range Detection | *f | Long-range Detection |
| *g | When panoramic view monitor system (When panoramic view screen is displayed) operates | *h | When panoramic view monitor system (panoramic view screen not displayed) operates |
| Detection Range | During Judgment | Obstacle |
|---|---|---|
| Close-range detection
Within approx. 300 +/- 50 mm (11.8 +/- 2.0 in.) |
Buzzer: Sounds continuously
Number of bars displayed: 1 (blinking) |
60 mm (2.36 in.) diameter pole |
| Medium-range detection
From approx. 300 +/- 50 to 450 +/- 50 mm (11.8 +/- 2.0 to 17.7 +/- 2.0 in.) |
Buzzer: Sounds intermittently (ON: 0.075 sec. / OFF: 0.075 sec.)
Number of bars displayed: 2 (illuminated) |
60 mm (2.36 in.) diameter pole |
| Long-range detection
From approx. 450 +/- 50 to 600 +/- 50 mm (17.7 +/- 2.0 to 23.6 +/- 2.0 in.) |
Buzzer: Sounds intermittently (ON: 0.15 sec. / OFF: 0.15 sec.)
Number of bars displayed: 3 (illuminated) |
60 mm (2.36 in.) diameter pole |
Ultrasonic waves are used to measure the detection range; however, the detection range may vary depending on the ambient temperature.
Rear center sonar display and buzzer operation check
When the No. 1 ultrasonic sensors (rear center sonar) have detected an obstacle, check the display and check that the buzzer sounds.
| Ignition Switch | Back Sonar or Clearance Sonar Switch Assembly | Shift Lever Position | Vehicle Speed |
|---|---|---|---|
| ON | On | R | - |
| *a | Multi-information Display | *b | Multi-display |
| *c | Example (Rear Center Sonar) | *d | Close-range Detection |
| *e | Medium-range Detection | *f | Long-range Detection |
| *g | Longest-range Detection | *h | When panoramic view monitor system (When panoramic view screen is displayed) operates |
| *i | When panoramic view monitor system (panoramic view screen not displayed) operates | - | - |
| Detection Range | During Detection | Obstacle |
|---|---|---|
| Close-range detection
Within approx. 400 +/- 50 mm (15.7 +/- 2.0 in.) |
Buzzer: Sounds continuously
Number of bars displayed: 1 (blinking) |
60 mm (2.36 in.) diameter pole |
| Medium-range detection
From approx. 400 +/- 50 to 500 +/- 50 mm (15.7 +/- 2.0 to 19.7 +/- 2.0 in.) |
Buzzer: Sounds intermittently (ON: 0.075 sec. / OFF: 0.075 sec.)
Number of bars displayed: 2 (illuminated) |
60 mm (2.36 in.) diameter pole |
| Long-range detection
From approx. 500 +/- 50 to 600 +/- 50 mm (19.7 +/- 2.0 to 23.6 +/- 2.0 in.) |
Buzzer: Sounds intermittently (ON: 0.15 sec. / OFF: 0.15 sec.)
Number of bars displayed: 3 (illuminated) |
60 mm (2.36 in.) diameter pole |
| Longest-range detection
From approx. 600 +/- 50 to 1500 +/- 150 mm (23.6 +/- 2.0 to 59.1 +/- 5.9 in.) |
Buzzer: Sounds intermittently (ON: 0.15 sec. / OFF: 0.65 sec.)
Number of bars displayed: 4 (illuminated) |
Wall |
Ultrasonic waves are used to measure the detection range; however, the detection range may vary depending on the ambient temperature.