Home › Steering › STEERING COLUMN › STEERING WHEEL › from 2016.11
RM3160E _55 Steering _019698 STEERING COLUMN _0101109 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.

·

Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly with the battery connected and the ignition switch ON.

·

Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.



PROCEDURE

Hide 45713A 1.INSTALL STEERING SHAKE DAMPER (for 2GR-FKS)

a.

Install the steering shake damper to the steering wheel assembly with the 2 screws.

Torque:
2.4 N*m (24 kgf*cm, 21 in.*lbf)


Hide 55910E 2.INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater)

Hide 84632 3.INSTALL CRUISE CONTROL MAIN SWITCH

Hide 84633 4.INSTALL CRUISE CONTROL SWITCH WIRE

a.

Install the cruise control switch wire.


Hide 84250A 5.INSTALL STEERING PAD SWITCH ASSEMBLY

Hide 6.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 84307 7.INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 45100 8.INSTALL STEERING WHEEL ASSEMBLY

a.
C291578C01
1.729,0.594 0.698,0.469 0.698,0.469 1.729,0.469 true 0.542,0.365 0.854,0.521 0.313,0.156 10 false *a

Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.


b.

Install the steering wheel assembly set nut.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


c.

w/ Steering Heater:

i.

Connect the connector to the steering wheel heater control assembly.



d.

Connect each connector to the spiral cable with sensor sub-assembly.


Hide 9.CHECK STEERING WHEEL CENTER POINT

Hide 45130 10.INSTALL HORN BUTTON ASSEMBLY