Home › Drivetrain › UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › PATTERN SELECT SWITCH › from 2016.11
RM3160E _52 Drivetrain _060164 UA80E AUTOMATIC TRANSMISSION / TRANSAXLE _0298237 PATTERN SELECT SWITCH G

UA80E AUTOMATIC TRANSMISSION / TRANSAXLE  PATTERN SELECT SWITCH  INSPECTION  


PROCEDURE

Hide 84720K 1.INSPECT PATTERN SELECT SWITCH ASSEMBLY

a.
E190200C03
2.031,1.448 2.25,1.958 2.25,1.958 2.375,1.958 true 1.406,1.448 1.219,1.948 1.219,1.948 1.094,1.948 true 0.177,0.146 0.375,0.323 0.198,0.177 10 false *a 2.469,1.875 2.927,2.146 0.458,0.271 10 false E 0.781,1.875 1.24,2.104 0.458,0.229 10 false 2ND
*a Component without harness connected (Pattern Select Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
8 (2ND) - 5 (E) Pattern select switch on (Push) Below 1 Ω
Pattern select switch off (Release) 10 kΩ or higher


If the result is not as specified, replace the pattern select switch assembly.


b.
E190200C04
1.594,1.458 1.396,1.969 1.396,1.969 1.25,1.969 true 1.844,1.469 1.979,1.927 1.979,1.927 2.135,1.927 true 0.177,0.146 0.375,0.323 0.198,0.177 10 false *a 0.948,1.896 1.521,2.177 0.573,0.281 10 false ILL+ 2.188,1.854 2.75,2.083 0.563,0.229 10 false ILL-
*a Component without harness connected (Pattern Select Switch Assembly)


Apply battery voltage between the terminals of the pattern select switch assembly, and check the illumination condition of the pattern select switch assembly.

Standard:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 7 (ILL+)
Battery negative (-) → Terminal 6 (ILL-)
Illuminates


If the result is not as specified, replace the pattern select switch assembly.