Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM WARNING BUZZER › from 2016.11
RM3160E _58 Vehicle Interior _060169 PRE-COLLISION _0298264 PRE-COLLISION SYSTEM WARNING BUZZER G

PRE-COLLISION  PRE-COLLISION SYSTEM WARNING BUZZER  INSPECTION  


PROCEDURE

Hide 86652A 1.INSPECT SKID CONTROL BUZZER ASSEMBLY

a.

Make sure that there is no looseness in the locking part and connecting part of the connector.


b.

Disconnect the skid control buzzer assembly connector.


c.

Check the connector and terminals for deformation and corrosion.

OK:

No deformation or corrosion.



d.
E315531

Connect a positive (+) lead from the battery to terminal 2, and a negative (-) lead to terminal 1 of the skid control buzzer assembly, and check that the buzzer sounds.

OK:

The skid control buzzer assembly sounds.


If the result is not as specified, replace the skid control buzzer assembly.