Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SWITCH › from 2016.11
RM3160E _56 Audio / Visual / Telematics _019702 PARK ASSIST / MONITORING _0298532 PANORAMIC VIEW MONITOR SWITCH G

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SWITCH  INSPECTION  


PROCEDURE

Hide 84721A 1.INSPECT PANORAMIC VIEW MONITOR SWITCH (FRONT WIDE VIEW SWITCH)

a.
E288364C01
2.229,1.896 1.99,1.896 1.99,1.896 1.99,1.469 false 1.26,1.896 1.469,1.896 1.469,1.896 1.469,1.469 false 0.083,0.083 0.396,0.281 0.313,0.198 10 false *a 2.302,1.833 2.615,2.031 0.313,0.198 10 false E 1.146,1.833 1.458,2.031 0.313,0.198 10 false D
*a Component without harness connected
(Panoramic View Monitor Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
11 (B) - 8 (D) Panoramic view monitor switch on (not protruding) Below 1 Ω
11 (B) - 8 (D) Panoramic view monitor switch off (protruding) 10 kΩ or higher


If the result is not as specified, replace the panoramic view monitor switch.


b.

Check that the switch illuminates.

i.
E288364C03
2.052,1.896 1.813,1.896 1.813,1.896 1.813,1.469 false 1.427,1.896 1.635,1.896 1.635,1.896 1.635,1.469 false 0.083,0.083 0.396,0.281 0.313,0.198 10 false *a 2.094,1.844 2.521,2.063 0.427,0.219 10 false ILL- 1.146,1.833 1.583,2.042 0.438,0.208 10 false ILL+
*a Component without harness connected
(Panoramic View Monitor Switch)


Apply battery voltage to the panoramic view monitor switch and check that the switch illuminates.

OK:
Connection Specified Condition
Battery positive (+) → Terminal 10 (ILL+)
Battery negative (-) → Terminal 9 (ILL-)
Illuminates


If the result is not as specified, replace the panoramic view monitor switch.