Avoid any impact to the blind spot monitor sensor.
Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.
The blind spot monitor beam axis confirmation is performed to confirm whether the sensor beam axis is correct, and to adjust the beam axis by using a reflector.
The blind spot monitor sensor installation condition inspection is performed to confirm whether the sensor is placed vertically to the ground (+/-4°) by using a jig, and that the sensor is 16 to 24° from the line parallel to the vehicle center line.
88172
1.INSTALL BLIND SPOT MONITOR SENSOR LH
|
Connector |
|
Bolt |
|
Nut |
Connect the connector.
Install the blind spot monitor sensor LH with the bolt and 2 nuts.
Tighten the bolt and nuts in the order shown in the illustration.
Replace the blind spot monitor sensor LH if it has been dropped or subjected to a severe impact.
88162
2.INSTALL BLIND SPOT MONITOR SENSOR RH
|
Connector |
|
Bolt |
|
Nut |
Connect the connector.
Install the blind spot monitor sensor RH with the bolt and 2 nuts.
Tighten the bolt and nuts in the order shown in the illustration.
Replace the blind spot monitor sensor RH if it has been dropped or subjected to a severe impact.
3.PERFORM BLIND SPOT MONITOR SENSOR INSTALLATION CONDITION INSPECTION
4.INSTALL REAR BUMPER ASSEMBLY
5.PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK
6.PERFORM DIAGNOSTIC SYSTEM CHECK