23860
1.INSPECT FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY LH (FUEL PRESSURE SENSOR)
Do not remove the fuel pressure sensor from the fuel delivery pipe with sensor assembly LH.
If the fuel pressure sensor is removed, replace the fuel delivery pipe with sensor assembly LH (fuel pressure sensor) with a new one.
Check the fuel pressure sensor output voltage.
| *a | Component without harness connected
(Fuel Pressure Sensor) |
| *b | Voltage Applied between Terminals |
Apply 5 V between terminals 1 (VC) and 2 (E2).
Be careful when connecting the leads as the fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.
Do not apply more than 6 V to terminals 1 (VC) or 2 (E2).
If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.
| *a | Component without harness connected
(Fuel Pressure Sensor) |
Measure the voltage between terminals.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (PR) - 2 (E2) | Pressure not applied to fuel pressure sensor | Approximately 0.4 to 0.6 V* |
*: The output voltage changes depending on the voltage applied to the terminals.
If the result is not as specified, replace the fuel delivery pipe with sensor assembly LH (fuel pressure sensor).