Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY
Engage the grommet.
Connect the connector to install the rear combination light socket and wire sub-assembly.
64740C
2.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)
64730B
3.INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)
66311
4.INSTALL ROPE HOOK
64725F
5.INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
64974
6.INSTALL DECK TRIM POCKET COVER
81330
7.INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for RH Side)
62627D
8.INSTALL SIDE TRIM COVER RH (for RH Side)
w/o Rear Automatic Air Conditioning System: Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
88625T
9.INSTALL COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR (for RH Side)
w/ Rear Automatic Air Conditioning System: Click hereVehicle Interior>HEATING / AIR CONDITIONING>ROOM TEMPERATURE SENSOR(for Rear)>INSTALLATION
73570
10.CONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY
64735
11.INSTALL DECK TRIM SIDE SERVICE HOLE COVER (for LH Side)
73297E
12.INSTALL DECK TRIM SIDE BELT HOLE COVER RH (for RH Side)
64715E
13.INSTALL NO. 2 DECK SIDE TRIM COVER (for LH Side)
64714H
14.INSTALL NO. 1 DECK SIDE TRIM COVER (for RH Side)
73370C
15.CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY
64713F
16.INSTALL FRONT DECK SIDE TRIM COVER
17.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
67918A
18.INSTALL REAR DOOR SCUFF PLATE
72138M
19.INSTALL REAR OUTER SEAT TRACK BRACKET COVER
20.INSTALL REAR NO. 2 SEAT ASSEMBLY
58387B
21.INSTALL REAR FLOOR FINISH PLATE
64993
22.INSTALL REAR DECK FLOOR BOX
64742C
23.INSTALL DECK SIDE TRIM BOX LH
64910J
24.INSTALL TONNEAU COVER ASSEMBLY
58409A
25.INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
58410B
26.INSTALL DECK BOARD ASSEMBLY
81550L
27.INSTALL REAR TURN SIGNAL LIGHT BULB
Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly.
81560
28.INSTALL REAR COMBINATION LIGHT ASSEMBLY
Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb as shown in the illustration to connect them as a unit.
Connect the connector.
Engage the 3 clamps.
| *a | Pin |
| *b | Guide |
Engage the guide and pin to temporarily install the rear combination light assembly as shown in the illustration.
Install the rear combination light assembly with the 2 screws.
Engage the 4 claws to install the rear combination light cover.