Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (for 4 Sensor Type) › from 2016.11
RM3160E _56 Audio / Visual / Telematics _019702 PARK ASSIST / MONITORING _0109512 TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type) D

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)  SYSTEM DESCRIPTION  


GENERAL


a.

This system uses ultrasonic sensors to detect any obstacles at the rear of the vehicle. The system then informs the driver of the distance between the sensors and an obstacle as well as their positions by indicating them on the multi-information display, multi-display and by sounding a buzzer.



FUNCTION OF COMPONENTS


Component Function
No. 1 Ultrasonic Sensor Detects the distance between the vehicle and an obstacle
No. 1 Clearance Warning Buzzer Sounds to inform the driver according to the distance to an obstacle
Multi-information Display (on Combination Meter Assembly)
·

Displays the location of an obstacle and the approximate distance between the vehicle and the obstacle

·

Displays a malfunction of the ultrasonic sensor to inform the driver


Clearance Sonar Indicator (on Combination Meter Assembly) Illuminates to inform the driver while the Toyota parking assist-sensor system power is on (the ignition switch is on and the back sonar or clearance sonar switch assembly is on)
Combination Meter Assembly Transmits the vehicle speed signal to the clearance warning ECU assembly
Back Sonar or Clearance Sonar Switch Assembly Operating this switch enables, disables or cuts off the operation of the Toyota parking assist-sensor system
Clearance Warning ECU Assembly
·

Judges the approximate distance between the vehicle and an obstacle based on the signals from the ultrasonic sensors and sends it to the multi-information display

·

Judges the approximate distance between the vehicle and an obstacle based on the signals from the ultrasonic sensors and sounds the buzzer


Main Body ECU (Multiplex Network Body ECU) Transmits the destination information to the clearance warning ECU assembly
ECM Transmits the shift position signal to the clearance warning ECU assembly
·

Radio and Display Receiver Assembly*1

·

Navigation Receiver Assembly*2


Receives the ultrasonic sensor information from the clearance warning ECU assembly through the CAN communication line, and displays them on the multi-display

*1: for Radio and Display Type

*2: for Navigation Receiver Type



OPERATION EXPLANATION


a.

The operating conditions of each ultrasonic sensor differ according to the installation position as shown in the table below.

Installation Position Operating Condition
Rear Corner
·

Ignition switch is on.

·

Back sonar or clearance sonar switch assembly is on.

·

Shift lever is in R.


Rear Center

When the system operates, the clearance warning ECU assembly transmits ultrasonic waves from the ultrasonic sensors. If these waves encounter an obstacle within one or more of the sensors ranges, the waves are reflected back to the sensors, which transmit them to the clearance warning ECU assembly.

Based on this information, the clearance warning ECU assembly sends signals to the radio and display receiver assembly*1 or navigation receiver assembly*2, the combination meter assembly and the No. 1 clearance warning buzzer. The approximate distance between the vehicle and the obstacle is then indicated, and the buzzer sounds.

*1: for Radio and Display Type

*2: for Navigation Receiver Type


HINT:

Refer to Detection Range Measurement and Display Inspection.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (for 4 Sensor Type)>OPERATION CHECK