Home › Engine / Hybrid System › 2GR-FKS EMISSION CONTROL › PURGE VALVE › from 2016.11
RM3160E _51 Engine / Hybrid System _060159 2GR-FKS EMISSION CONTROL _0299803 PURGE VALVE G

2GR-FKS EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT PURGE VALVE (PURGE VSV)

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω


If the result is not as specified, replace the purge valve (purge VSV).


b.
A373705C01
1.313,1.344 1.313,0.833 true 0.677,0.688 0.469,0.323 0.469,0.323 0.323,0.323 true 1.229,1.396 1.552,1.698 0.323,0.302 10 false *a 0.104,0.229 0.406,0.51 0.302,0.281 10 false *b 2.021,1.615 2.333,1.906 0.313,0.292 10 false *c 0.094,1.042 0.354,1.292 0.26,0.25 10 false *d
*a Port (E)
*b Port (F)
*c Air
*d Component without harness connected
(Purge Valve (Purge VSV))


Apply battery voltage between the terminals of the purge valve (purge VSV) and check that the following occurs when blowing air into the port (E).

OK:
Measurement Condition Specified Condition
Battery voltage applied between terminals 1 and 2 Air flows from port (F)
Battery voltage not applied between terminals 1 and 2 Air does not flow


If the result is not as specified, replace the purge valve (purge VSV).