1.INSPECT WSH NZL HTR RELAY
| *a | Component without harness connected
(WSH NZL HTR Relay) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied between terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied between terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the WSH NZL HTR relay.