Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM › from 2016.11
RM3160E _59 Vehicle Exterior _019721 WIPER / WASHER _0097860 WIPER AND WASHER SYSTEM L

WIPER / WASHER  WIPER AND WASHER SYSTEM  PRECAUTION  


PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected:

System See Procedure
Lane Departure Alert System (w/ Steering Control) (Click here)
Parking Assist Monitor System
Panoramic View Monitor System
Power Door Lock Control System
Pre-collision System
Air Conditioning System (for Automatic Air Conditioning System)
Air Conditioning System (for Manual Air Conditioning System)
Power Back Door System



IGNITION SWITCH EXPRESSIONS


a.

The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off (Lock)
Ignition Switch ACC ACC On (ACC)
Ignition Switch ON ON On (IG)
Engine Start START On (Start)



PRECAUTION OF WASHER NOZZLE ADJUSTMENT


a.

Do not clean or adjust the washer nozzle with a safety pin, etc. because:

i.

The washer nozzle tip is made of resin and could be damaged.


ii.

Adjustment is not necessary for this spray type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.

Click hereVehicle Exterior>WIPER / WASHER>WASHER NOZZLE(for Front Side)>ADJUSTMENT



b.

If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.



PRECAUTIONS FOR INSPECTING POWER SOURCE FOR MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (for LHD)


a.

As the door control battery is installed between the vehicle battery and main body ECU (multiplex network body ECU), a door control battery malfunction can be suspected if the power source for the main body ECU (multiplex network body ECU) is malfunctioning.