Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2016.11
RM3160E _58 Vehicle Interior _060169 PRE-COLLISION _0296083 PRE-COLLISION SYSTEM U

PRE-COLLISION  PRE-COLLISION SYSTEM  TERMINALS OF ECU  


CHECK DRIVING SUPPORT ECU ASSEMBLY


E321781E44
3.385,0.115 3.833,0.354 0.448,0.24 3.458,0.156 4.073,0.354 0.615,0.198 10 false F128

a.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F128-7 (B) - F128-28 (GND) R - W-B Power source Engine switch on (IG) 11 to 14 V
Engine switch off Below 1 V
F128-3 (BZ) - F128-28 (GND) L - W-B Skid control buzzer assembly output Engine switch on (IG), buzzer not sounding 11 to 14 V
Engine switch on (IG), buzzer sounding Below 1 V
F128-28 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω


b.

Check for pulses according to the value(s) in the table below.

HINT:

If the waveform is not similar to that shown in the illustration, a malfunction of a CAN bus line, terminating resistor, or the driving support ECU assembly is suspected.


Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F128-8 (CA1P) - F128-28 (GND) B - W-B CAN communication signal Engine switch on (IG) Pulse generation
(See waveform 1)
F128-9 (CA1N) - F128-28 (GND) W - W-B CAN communication signal Engine switch on (IG) Pulse generation
(See waveform 2)
F128-10 (CA2H) - F128-28 (GND) G - W-B CAN communication signal Engine switch on (IG) Pulse generation
(See waveform 1)
F128-11 (CA2L) - F128-28 (GND) W - W-B CAN communication signal Engine switch on (IG) Pulse generation
(See waveform 2)

i.
A086154E97
2.75,0.271 3.365,0.521 0.615,0.25 10 false 1 V/DIV. 1.365,1.906 2.313,2.094 0.948,0.188 10 false 10 μsec./DIV.

WAVEFORM 1

Item Content
Terminal Name Between F128-8 (CA1P) - F128-28 (GND)
Between F128-10 (CA2H) - F128-28 (GND)
Tester Range 1 V/DIV., 10 μsec./DIV.
Condition Engine switch on (IG)

HINT:

The waveform varies depending on the CAN communication signal.



ii.
A086155E89
2.76,0.281 3.396,0.51 0.635,0.229 10 false 1 V/DIV. 1.365,1.875 2.333,2.073 0.969,0.198 10 false 10 μsec./DIV.

WAVEFORM 2

Item Content
Terminal Name Between F128-9 (CA1N) - F128-28 (GND)
Between F128-11 (CA2L) - F128-28 (GND)
Tester Range 1 V/DIV., 10 μsec./DIV.
Condition Engine switch on (IG)

HINT:

The waveform varies depending on the CAN communication signal.





CHECK MILLIMETER WAVE RADAR SENSOR ASSEMBLY


E321782E30
2.167,0.75 2.583,1 0.417,0.25 2.26,0.792 2.719,0.99 0.458,0.198 10 false A81

a.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
A81-8 (IGB) - A81-1 (SGND) R - BR Power source Engine switch on (IG) 11 to 14 V
A81-1 (SGND) - Body ground BR - Body ground Ground Always Below 1 Ω


b.

Check for pulses according to the value(s) in the table below.

HINT:

If the waveform is not similar to that shown in the illustration, a malfunction of a CAN bus line, terminating resistor, or the millimeter wave radar sensor assembly is suspected.


Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
A81-3 (CA2H) - A81-1 (SGND) P - BR CAN communication signal Engine switch on (IG) Pulse generation
(See waveform 1)
A81-2 (CA2L) - A81-1 (SGND) W - BR CAN communication signal Engine switch on (IG) Pulse generation
(See waveform 2)
A81-5 (CA1P) - A81-1 (SGND) B - BR CAN communication signal Engine switch on (IG) Pulse generation
(See waveform 1)
A81-6 (CA1N) - A81-1 (SGND) W - BR CAN communication signal Engine switch on (IG) Pulse generation
(See waveform 2)

i.
A086154E97
2.75,0.271 3.365,0.521 0.615,0.25 10 false 1 V/DIV. 1.365,1.906 2.313,2.094 0.948,0.188 10 false 10 μsec./DIV.

WAVEFORM 1

Item Content
Terminal Name Between A81-3 (CA2H) and A81-1 (SGND)
Between A81-5 (CA1P) and A81-1 (SGND)
Tester Range 1 V/DIV., 10 μsec./DIV.
Condition Engine switch on (IG)

HINT:

The waveform varies depending on the CAN communication signal.



ii.
A086155E89
2.76,0.281 3.396,0.51 0.635,0.229 10 false 1 V/DIV. 1.365,1.875 2.333,2.073 0.969,0.198 10 false 10 μsec./DIV.

WAVEFORM 2

Item Content
Terminal Name Between A81-2 (CA2L) and A81-1 (SGND)
Between A81-6 (CA1N) and A81-1 (SGND)
Tester Range 1 V/DIV., 10 μsec./DIV.
Condition Engine switch on (IG)

HINT:

The waveform varies depending on the CAN communication signal.