Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2016.11
RM3160E _58 Vehicle Interior _060169 PRE-COLLISION _0296083 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  C1A63  Other System Malfunction  


DESCRIPTION

The driving support ECU assembly receives accelerator pedal position sensor signals from the ECM to determine if the accelerator pedal is being depressed. If the ECM detects a malfunction in the accelerator pedal position sensor or SFI system, the driving support ECU assembly is notified via CAN communication and stores DTC C1A63.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A63 Other System Malfunction With the engine switch is on (IG), the driving support ECU assembly receives an accelerator pedal position sensor malfunction signal from the ECM for approximately 5 seconds or more. SFI system

PROCEDURE

1.GO TO SFI SYSTEM
HINT:

If DTC C1A63 is output by the pre-collision system, perform troubleshooting for the SFI system.



Result:
Proceed to
NEXT



NEXT

END