Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2016.11
RM3160E _58 Vehicle Interior _060169 PRE-COLLISION _0296083 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0125  Lost Communication with Yaw Rate Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  


DESCRIPTION

The driving support ECU assembly uses the millimeter wave radar sensor assembly to detect objects in front of the vehicle. Based on signals from the millimeter wave radar sensor assembly, the driving support ECU assembly sends pre-collision system control operation signals. These DTCs are stored when a communication malfunction occurs between ECUs that perform pre-collision system control.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0100 Lost Communication with ECM / PCM "A" When the vehicle is being driven at a speed of 5 km/h (4 mph) or more, a communication error between the ECM and the driving support ECU assembly is detected for approximately 5 seconds.
·

CAN communication system

·

ECM

·

Driving support ECU assembly

·

Wire harness or connector


U0125 Lost Communication with Yaw Rate Sensor Module When the engine switch is on (IG), a communication error between the yaw rate sensor (airbag sensor assembly) and the driving support ECU is detected for approximately 1 second.
·

CAN communication system

·

Yaw rate sensor (Airbag sensor assembly)

·

Driving support ECU assembly

·

Wire harness or connector


U0126 Lost Communication with Steering Angle Sensor Module When the engine switch is on (IG), a communication error between the steering sensor and the driving support ECU assembly is detected for approximately 4 seconds.
·

CAN communication system

·

Steering sensor

·

Driving support ECU assembly

·

Wire harness or connector


U0129 Lost Communication with Brake System Control Module When the engine switch is on (IG), a communication error between the skid control ECU (brake actuator assembly) and the driving support ECU assembly is detected for approximately 3 seconds.
·

CAN communication system

·

Skid control ECU (Brake actuator assembly)

·

Driving support ECU assembly

·

Wire harness or connector



PROCEDURE

1.CHECK FOR DTCs (PRE-COLLISION SYSTEM)
a.

Clear the DTCs.

Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>DTC CHECK / CLEAR

Body Electrical > Pre-Collision 2 > Clear DTCs
50002 220

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Drive the vehicle at a speed of 5 km/h (4 mph) or more for 5 seconds or more.




c.

Check for DTCs.

Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>DTC CHECK / CLEAR

Body Electrical > Pre-Collision 2 > Trouble Codes
50001 220

Result:
Result Proceed to
DTC U0100, U0125, U0126 and U0129 are not output A
DTC U0100, U0125, U0126 or U0129 is output B



A

B