Home › Engine / Hybrid System › 2GR-FKS (ENGINE CONTROL) › MASS AIR FLOW METER › from 2016.11
RM3160E _51 Engine / Hybrid System _060156 2GR-FKS ENGINE CONTROL _0303256 MASS AIR FLOW METER G

2GR-FKS ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

a.
A334357C01
0.906,1.01 1.719,1.01 true 0.719,0.917 1.031,1.073 0.313,0.156 10 false *a
*a Thermistor


Perform a visual check for any foreign matter on the temperature sensor (thermistor) of the mass air flow meter sub-assembly shown in the illustration.

OK:

There is no foreign matter.


If the result is not as specified, replace the mass air flow meter sub-assembly.


b.
A334358C01
0.531,0.615 0.833,0.615 0.833,0.615 1.229,1.177 true 2.573,0.604 2.198,0.604 2.198,0.604 1.906,1.167 true 0.094,0.115 0.406,0.271 0.313,0.156 10 false *a 0.198,0.531 0.656,0.729 0.458,0.198 10 false THA 2.635,0.51 3.094,0.708 0.458,0.198 10 false E2G
*a Component without harness connected
(Mass Air Flow Meter Sub-assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (THA) - 2 (E2G) -20°C (-4°F) 13.6 to 18.4 kΩ
20°C (68°F) 2.21 to 2.69 kΩ
60°C (140°F) 0.49 to 0.67 kΩ


If the result is not as specified, replace the mass air flow meter sub-assembly.