When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT
1.INSTALL FRONT BUMPER ASSEMBLY
Move the front bumper assembly into position.
Temporarily install the front bumper assembly with the 3 clips as shown in the illustration.
w/ Panoramic View Monitor System:
Connect the connector.
Pull back the side of the front bumper assembly, connect each connector and engage each clamp.
Do not apply excessive force when pulling back the front bumper assembly.
Engage the 4 claws.
Use the same procedure for the RH side and LH side.
Install the front bumper assembly with the 8 screws.
75086
2.CONNECT FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY LH
Engage the 2 clips and 4 claws.
Install the clip.
| *1 | Pin Hold Clip |
| *a | Correct |
| *b | Incorrect |
Install the clip.
Connect the front fender wheel opening moulding sub-assembly LH with the 2 screws.
Install the pin hold clip as shown in the illustration.
Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.
75085A
3.CONNECT FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
4.INSTALL RADIATOR GRILLE ASSEMBLY
5.ADJUST FOG LIGHT ASSEMBLY
86790B
6.ADJUST FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)