Home › Drivetrain › UA80F (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH › from 2016.11
RM3160E _52 Drivetrain _060165 UA80F AUTOMATIC TRANSMISSION / TRANSAXLE _0303755 PARK / NEUTRAL POSITION SWITCH A

UA80F AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
C332327

·

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 17705 3.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 17801 4.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

a.

Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.


Hide 17701 5.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

a.
C370291

Remove the 2 bolts.


b.

Disengage the guide from the grommet of the air cleaner support bracket to remove the air cleaner case sub-assembly.


Hide 33820B 6.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C363257C01
2.417,1.844 2.469,2 2.469,2 2.646,2 false 2.677,1.885 2.99,2.083 0.313,0.198 10 false *a
*a Clip


Remove the clip as shown in the illustration and disconnect the transmission control cable assembly from the transmission control shaft lever.


Hide 84540 7.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.
C361028

Disconnect the park/neutral position switch assembly connector.


b.

Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.


c.
C366787

Remove the 2 bolts and park/neutral position switch assembly from the automatic transaxle case sub-assembly.

NOTICE:

Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the manual valve lever shaft sub-assembly. Be sure to remove the park/neutral position switch assembly straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch assembly cannot be reinstalled correctly.