84720K
1.INSPECT PATTERN SELECT SWITCH ASSEMBLY
| *a | Component without harness connected (Pattern Select Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 8 (2ND) - 5 (E) | Pattern select switch on (Push) | Below 1 Ω |
| Pattern select switch off (Release) | 10 kΩ or higher |
If the result is not as specified, replace the pattern select switch assembly.
| *a | Component without harness connected (Pattern Select Switch Assembly) |
Apply battery voltage between the terminals of the pattern select switch assembly, and check the illumination condition of the pattern select switch assembly.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 7 (ILL+)
Battery negative (-) → Terminal 6 (ILL-) |
Illuminates |
If the result is not as specified, replace the pattern select switch assembly.