Home › Power Source / Network › 1AR-FE BATTERY / CHARGING › CHARGING SYSTEM › from 2016.11
RM3160E _57 Power Source / Network _019679 1AR-FE BATTERY / CHARGING _0105676 CHARGING SYSTEM L

1AR-FE BATTERY / CHARGING  CHARGING SYSTEM  PRECAUTION  


PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System Name See Procedure
Parking Assist Monitor System (Click here)
Power Door Lock Control System
Air Conditioning Ststem (for Automatic Air Conditioning System)
Air Conditioning Ststem (for Manual Air Conditioning System)
Power Back Door System
Lane departure alert system (w/ Steering Control)
Pre-collision system
Panoramic View Monitor System



IGNITION SWITCH EXPRESSIONS


a.

The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off (Lock)
Ignition Switch ACC ACC On (ACC)
Ignition Switch ON ON On (IG)
Engine Start START On (Start)



NOTICE:
·

Check that the battery cables are connected to the correct terminals.

·

Disconnect the battery cables when the battery is given a quick charge.

·

Do not perform tests with a high voltage insulation resistance tester.

·

Never disconnect the battery cables while the engine is running.

·

Check that the charging cable nuts are tightened on terminal B of the generator assembly and on the engine room relay block and junction block assembly.