Home › Engine / Hybrid System › 1AR-FE ENGINE CONTROL › ECM › from 2016.11
RM3160E _51 Engine / Hybrid System _019671 1AR-FE ENGINE CONTROL _0106851 ECM A

1AR-FE ENGINE CONTROL  ECM  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

Perform Vehicle Identification Number (VIN) registration when replacing the ECM.

Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>SFI SYSTEM>REGISTRATION

·

If the ECM has been struck or dropped, replace it.

·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

Before replacing the ECM, refer to Service Bulletin.



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE AIR CLEANER ASSEMBLY

a.
A316191

Disconnect the mass air flow meter sub-assembly connector and disengage the wire harness clamp.


b.
A313532

Remove the 2 bolts from the air cleaner assembly.


c.

Loosen the hose clamp and separate the air cleaner assembly from the No. 1 air cleaner hose.


d.

Separate the air cleaner assembly from the inlet air cleaner assembly.


e.

Disengage the clamp to remove the air cleaner assembly.


Hide 89661 4.REMOVE ECM

a.
A313533

Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

NOTICE:

After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.



b.
A313534

Disengage the wire harness clamp.


c.

Remove the 3 bolts and ECM.

NOTICE:

If the ECM has been struck or dropped, replace it.



Hide 89667 5.REMOVE ECM BRACKET

a.
A313535

Remove the 2 screws and ECM bracket from the ECM.


Hide 89668 6.REMOVE NO. 2 ECM BRACKET

a.
A313536

Remove the 2 screws and No. 2 ECM bracket from the ECM.