CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
Disconnect the F80 air conditioning amplifier assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
Measure the values on the wire harness side with the connector disconnected.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F80-1 (IG+) - F80-14 (GND) | V - BR | Power source (IG) | Ignition switch ON | 11 to 14 V |
| F80-1 (IG+) - F80-14 (GND) | V - BR | Power source (IG) | Ignition switch off | Below 1 V |
| F80-21 (B) - F80-14 (GND) | P - BR | Battery power supply | Always | 11 to 14 V |
| F80-14 (GND) - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
Reconnect the F80 air conditioning amplifier assembly connector.
Measure the voltage and check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F80-38 (RDFG) - F80-14 (GND) | L*1, R*2 - BR | Rear window defogger signal | Ignition switch ON, rear window defogger switch off | 11 to 14 V |
| F80-38 (RDFG) - F80-14 (GND) | L*1, R*2 - BR | Rear window defogger signal | Ignition switch ON, rear window defogger switch on | Below 2.2 V |
| F80-37 (LIN1) - F80-14 (GND) | BE - BR | LIN communication line | Ignition switch ON | Pulse generation |
*1: for LHD
*2: for RHD
CHECK AIR CONDITIONING CONTROL ASSEMBLY
Disconnect the F32 air conditioning control assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
Measure the values on the wire harness side with the connector disconnected.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F32-4 (IG+) - F32-5 (GND) | V - BR | Power source (IG) | Ignition switch ON | 11 to 14 V |
| F32-4 (IG+) - F32-5 (GND) | V - BR | Power source (IG) | Ignition switch off | Below 1 V |
| F32-5 (GND) - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
Reconnect the F32 air conditioning control assembly connector.
Check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F32-8 (LIN1) - F32-5 (GND) | BE - BR | LIN communication line | Ignition switch ON | Pulse generation |