Home › Vehicle Exterior › BODY PANEL › FRONT SIDE MEMBER FRONT
BM37A0E _01 Vehicle Exterior _087817 BODY PANEL _0419604 FRONT SIDE MEMBER FRONT F

BODY PANEL  FRONT SIDE MEMBER FRONT  CUT AND JOIN REPLACEMENT SECTIONS  


K156357

With the radiator side support assembly removed.


REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108819

Remove Weld Points
K108820

Remove Weld Points
K108827

Cut and Join Location

a.

Do not butt weld or heat repair because the heat decreases the strength of areas where ultra high strength steel is used. (See the introduction)

K156156

K156157C01
2.167,3.625 2.479,3.781 0.313,0.156 10 false *a
*a 15 mm (0.59 in.) - -




INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108824

Plug Weld
K108825

Plug Weld
K108831

Butt Weld

a.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

K156158C01
6.042,2.729 6.25,2.25 6.25,2.25 6.417,2.25 false 6.479,2.146 6.792,2.302 0.313,0.156 10 false *1
*1 FRONT SIDE MEMBER ASSEMBLY - -
*a Ultra High Strength Steel Welding Point - -


Follow the welding conditions below when welding ultra high strength steel to assure sufficient weld strength. (When repairing this model)

When welding 3 panels or more together including 780 MPa ultra high strength steel. (When plug welding a third panel to 2 panels which are welded under the conditions described above.)

*a: Plug weld Plug diameter 10 mm (0.39 in.)
Wire type AWS A5.18 ER70S-3
Shield gas Metal active gas

NOTICE:

Be sure to use Metal active gas (Ar 80% + CO2 20%) as the shield gas when plug welding.Sufficient weld strength cannot be assured when using 100% CO2 shield gas.



K156159C01
2.667,2.344 2.75,3 2.75,3 2.917,3 false 2.979,2.896 3.292,3.052 0.313,0.156 10 false *1
*1 REAR SIDE MEMBER SUB-ASSEMBLY - -



b.

After welding, apply body sealer to the corresponding parts. (See the painting/coating)


c.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.